Declaration Of Conformity - Bose ControlSpace AMS-8 Instrucciones De Seguridad Y Guía De Instalación

All manuals and user guides at all-guides.com
1. Safety information

Declaration of Conformity

The manufacturer of this amplifier hereby declares that this product, including its accessories,
is in compliance with the following standards:
EMC Directive 89/336/EEC (Electromagnetic Compatibility)
EN-55103-1
EN-55103-2
Low Voltage Directive 73/23/EEC
EN-60065:2002 7th Edition
Rack mounting considerations
The audio signal processor requires two 4.4 cm (1.75") rack space units with 32.5 cm (12.8") inside depth.
When mounting, use four screws with washers to prevent marring the front panel. Neoprene rubber
washers are a good choice because they grip the screw heads and prevent the screws from backing out
due to vibration or during transportation.
Caution: If the unit is rack-mounted and the rack is transported, you must mechanically support the rear
of the processor. You can place a shelf across the rear of the processor or use brackets to support the rear
unit.
General precautions & Ventilation
Caution: Place the unit where it will be protected from heat and allow adequate ventilation. Place the
unit away from direct heat sources, such as heating vents and radiators. Make sure the air can circulate
freely behind, beside and above the unit.
If the unit is placed under or above an amplifier, make sure a single unit ventilation plate is placed
between the 2 devices.
Do not allow the chassis to exceed the maximum operating temperature of 50ºC. Be aware of conditions in
an enclosed rack that may increase the temperature above above ambient room conditions.
Cautions: Be sure all the fine cores of the wire are twisted together and contained within the connector.
If even one core is loose it can touch the adjacent terminal, which may cause a short circuit.
6