GET RX1 PRO Manual Del Usuario página 11

PROCEDURE B
RX1PRO FW.CODE lower than RX1PRO14
1.
Keeping the ECU
plugged in, disconnect
the fuel pump power
supply, which is the
electric loom
to the fuel tank. Check
in your
workshop manual where
to find the fuel pump
power supply.
2.
Connect the RESET
TPS cable (included in
the box) to RX1 PRO ECU
"MAIN" connector.
3.
Connect
charged 12V battery to
"RESET TPS" cable: first,
red wire to positive pole
(+), and then black wire
to negative pole (-).
leading
motorbike's
a fully
2
11
1
EN