KENMORE ELITE 465.1332 Serie Manual De Instrucciones página 12

C
YCLES
Choose the cycle that best describes your dish load by pressing the corresponding touchpad (select models) or by
pressing the Cycle select pad (select models) until the desired cycle is lit. (See page 6, Start Up Guide, for how to
begin the cycle).
In addition to choosing a cycle, choose as many available options as necessary for your load.
• Cycles and options cannot be changed after the cycle has started.
• If Anti-Bacterial (select models) is selected, Sani-Rinse (select models) will automatically be selected
and can not be cancelled.
CYCLES
An adaptive cycle that adjusts the
number of fills, wash times and
Smart
temperatures based on the turbidity of
Sense ™ *
+
the water. The turbidity sensor
(select models)
determines the dish soil level and
selects the proper wash cycle.
A long cycle that uses more time, water
Heavy Wash and applied heat than the Normal Wash
cycle.
When the cycle monitor recognizes that
the proper conditions have been met, the
Anti-
Sanitized light will activate at the end of
Bacterial
the cycle. Sanitization may not be
+
achieved if there is an interruption of the
(select models)
cycle, power failure or if the incoming
water temperature is below 120° F (49° C).
Normal
A medium cycle for washing loads
with normal food soil levels.
Wash*
+
Use this cycle for lightly soiled china
China- and crystal. This cycle uses a gentle
wash and rinse. Towel drying may be
Gentle
required.
Quick
Quick cycle for light food soil. Towel
drying may be required
Wash
Use this rinse cycle when rinsing place
settings you plan to wash later, or for
Quick
freshening up dishes that have been
Rinse
stored for a period of time.
Only these cycles has been designated to meet NSF requirements (NSF/ANSI 184 Residential Dishwasher).
+
* Number of fills will vary depending on the soil level of each load.
**Times are based on immediate availability of 120° F hot water at the start of the cycle. This can be achieved by turning on the kitchen
faucet and running water until hot prior to starting the dishwasher.
Notes:
• All times are approximate.
• Fill length varies between different models.
• Fill time will vary depending on water pressure.
• Cycle times shown will increase or decrease based on each
load's soil level, water temperature and selected options.
All manuals and user guides at all-guides.com
, O
PTIONS AND
DESCRIPTION
L
TIME
NUMBER OF
(APPROX.
WASHES/RINSES
MINS.)
Min. 57
1 wash/2 rinses
Max. 138**
4 washes/2 rinses
80 4 washes/2 rinses
4 washes/2 rinses
80
Min. 57 1 wash/2 rinses
Max. 95**
4 washes/2 rinses
60
1 wash/2 rinses
1 wash/2 rinses
38
18
• Fan dry can be 30 minutes up to 4 hours depending on
cycles selected. Dry time is optimized per cycle
performance by selecting Sensor Dry.
• If the drawer is open for more than 30 seconds during the
intermittent drying time, intermittent dry will shut off.
• Even if rinse aid is used, the first few loads may leave
dishes with more water than normal. This effect will
dissipate after a few loads.
11
IGHTS
USE WITH
OPTIONS
Sensor Dry
(select models)
Sani-Rinse+
(select models)
High Temp Wash
Delay Hours
High Temp Wash
Delay Hours
Sensor Dry
Sani-Rinse+
High Temp Wash
Delay Hours
Sensor Dry
Sani-Rinse+
High Temp Wash
Delay Hours
Sensor Dry
High Temp Wash
Delay Hours
Delay Hours
2 rinses
_