Functional Description; Assembly; Installing / Removing Socket On The Anvil; Operating The Impact Wrench - Kawasaki 691767 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

3
9
4
2
12
6
CONTROLS AND COMPONENTS:
1. Trigger Switch
2. Forward/Reverse Lever
3. Gear Enclosure
4. Anvil
5. Comfort Non-slip Grip
6. 12V Plug-in (fuse inside)
7. Bubble Level
8. Motor Fan Air Vent
Always disconnect impact wrench from the power source
before installing,adjusting or removing any accessory in this tool, or before
performing maintenance. Failure to do so could result in injury.
All manuals and user guides at all-guides.com
7
5
1
11
13
10
9. Dent Pin
10. 12V Power Cord
11. LED Light
ACCESSORIES:
12. 1/2 in. (1.27 cm) Drive Impact
Socket (2)
13. 10A Fuse (2)

ASSEMBLY

9
8
contact with skin and use proper protective gloves when grasping the socket,
bit or accessory. Accessories may be hot after prolonged use.
When installing a socket,
align the holes in the side of
the socket with the dent pin.
Press the socket on until the
dent pin engages in the hole.
To remove a socket, pull the
socket off the anvil.
Never tape the trigger switch down to provide continuous high speed. The
tool may fail under such conditions causing fire or personal injury.
Take care when working around a running engine. Run engine in open, well-
ventilated areas ONLY. Running an engine in an enclosed space will allow
build-up of carbon monoxide gas which can lead to dizziness, headaches,
vomiting or death.
Keep hair, clothing, cables or wires out of reach of moving parts while the
engine is running.

INSTALLING / REMOVING SOCKET ON THE ANVIL

When removing the socket or bit from the tool, avoid

OPERATING THE IMPACT WRENCH

10