Abicor Binzel CAT2 Instructivo De Servicio página 37

CAT2
1
16
15
14 13
1 Torch
2 Torch mount
3 Dowel screw M8
4 Helix cable
5 Connector housing
6 4 protection caps
Fig. 6 Mount CAT2 on the robot
1 Fasten torch mount (2) with dowel screw (3), washer (16) and nut (15) to
the mount (11).
NOTICE
• The fastening of the torch (1) depends on the respective torch type.
2 Fasten complete torch on torch mount (2).
3 Remove the protection caps (6). Insert an Allen key into the bore and
remove the protection caps (6).
NOTICE
• Ensure correct position of the connector housing.
4 Mount CAT2 (10) on the robot flange (8) using four cylinder screws (9).
5 Reinsert the protection caps (6).
The following steps refer to the assembly of CAT2. For further assembly of the
CAT2 HL:
 6.1.1 CAT2 HL on page EN-17
All manuals and user guides at all-guides.com
2 3 4
12 11
7 Robot
8 Robot flange
9 4 cylinder screws
10 CAT2
11 Mount
 Fig. 5 Functional diagram on page EN-13
6 Putting into operation
5 6
7
8
10 9
12 Clamping ring
13 Cone clamping element
14 Cylinder screw M8
15 Nut
16 Washer
EN - 15