kayami AF 9000 Manual De Uso Y Cuidado página 46

IDENTIFICATION OF PARTS
Each mode working principle
* mode:
1. Once the Operation is selected, the indoor temperature sensor operates
automatically to select the desired operation mode with
2. When the room temperature ≥24 ºC,the unit will automatically select
3. When the room tempperature <24 ºC,the unit will automatically select
* mode:
1. The up centrifugal fan will run at low speed ,and the speed can't be adjusted.
2. The compressor and the down centrifugal fan will stop after running 8 mins, then run again after 6mins.
3. The unit adopts constant temperature dehumidifying mode,and the adjustment of temperature is no effective.
* mode:
1. When the room temperature is higher than set temperature ,the compressor starts to run.
2. When the room temperature is lower than set temperature ,the compressor stop and upper fan operate at original
set speed.
* mode:
1. The up centrifugal fan runs at set speed , and the compressor and down centrifugal fan does not run.
2. The adjustment of temperature is no effective.
* operation:
1. Press "Timer" button to set Automatic Off time while the unit is running.
2. Press "Timer" button to set Automatic On time while the unit is ready.
3. The time can be adjusted within a range of 1 hour to 24 hour. Press the temp up (
increase or decrease the time 1 hour by pressing once.
* operation:
1. Press the button in
to low speed automatically.The set temperature will increase 1 ºC after one hour,and increase 2 ºC after two hours.
After six hours, the unit will stop running.
Notice:
The main control board has memory function, when the unit is ready to run but in stop status, the main control board
can memorize the initialization of working mode. When you tun on the unit ,it will work as the same enactment of
working-mode as last time,no need to reset the working mode again. (This condition is not available when the unit is
under " " mode).
mode, then the unit will work under sleep mode and the indoor centrifugal fan will turn
44
or .
mode.
mode.
) or temp down ( ) button to