Tripp-Lite NGI-U08C2 Manual Del Propietário página 15

Wiring Power Input
Wiring Power Input (NGI-U05C2POE4 and
NGI-U05POE4 Models Only)
You can use "PWR" from the terminal block or 4-pin Mini-DIN for Power
input.
Top view of connectors are shown below:
Terminal Block
Caution:
• Use copper conductors only.
• Use wiring cable with rated temperature at least 221°F
(105°C).
• Tighten the wire to a torque value 4.5 lb•in (0.5 N•m).
• The wire gauge for the terminal block should range between
12~18 AWG (4~0.75 mm2).
Connecting to Terminal Block
To insert the power wire and connect the +24~57VDC at a maximum of
6A DC power to the power terminal block:
• Use a flathead screwdriver to loosen the wire clamp screws.
• Insert the negative/positive DC wires into the PWR-/PWR+ terminals,
respectively.
• Tighten the wire clamp screws to prevent the wires from loosening.
Mini-DIN
15