Publicidad
Step
Description
Use the supplied M5x12mm phillips
4
head screw to attach the plastic covers
over the attachment points on both
sides, between the seat cushion and
the seat back.
Then, snap the plastic cap to hide the
screw heads for a more finished look.
Attach the seat assembly to the base
5
by sliding the gas lift cylinder into the
center hole of the mechanical base.
Attach the headrest and the lumbar
pillow if you wish to use them for
extra support.
Run the straps through the holes and
6
snap them together on the backside
of the chair.
Adjust the height of both cushions
and enjoy your new Thrónos chair
from Primus.
Image
Publicidad
