Publicidad
RPA Elite Series Projector Mount
2c
2d
3
12
1
X 6
2
Securing Projector with Interface Bracket
to Model RPM Mount.
WARNING:
IMPROPER INSTALLATION CAN
LEAD TO PROJECTOR FALLING RESULTING IN
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT. Make certain mounting slots in mount
base slide under thumb screws and that screws are
seated in the back of slots.
1.
Turn six thumb screws until tight to secure projector
to mount.
NOTE:
This step applies only to Model RPM. See the
procedure below and firgure 2d for instruction
on securing Models RPM-A, RPM-B and RPM-
C to interface bracket.
Securing Projector with Interface Bracket
to Model RPM-A, RPM-B and RPM-C
Mounts.
WARNING:
IMPROPER INSTALLATION CAN
LEAD TO PROJECTOR FALLING RESULTING IN
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT. Make certain mounting slots in mount
base slide under thumb screws and that screws are
seated in the back of slots.
1.
Verify mounting screws are properly seated in
mounting slots in mount base.
2.
Move locking lever to "Locked" position as shown in
figure 2d at left.
3.
Insert key into lock and turn to secure projector to
mount.
Installation Instructions
Publicidad
