CUISIMAT V90 Manual De Uso Y Mantenimiento página 15

GB
INSTALLATION
Comply with the safety recommendations indicated above and hereafter when installing the
appliance.
1. Make sure that the mains voltage is as indicated on the rating label of the appliance and that
the electric system is grounded and equipped with a differential switch.
Install the appliance in a DRY, PROTECTED place, far from water sprays or splashes, heat
2.
sources, open flames and inflammable substances.
Place the appliance on a flat, horizontal, stable surface where it cannot tip over.
3. Make sure the switch on the appliance is in the "OFF" position and plug it into a socket
protected by a magneto thermal switch or fuses.
Do not use a multiple outlet plug.
Stretch the power cable out to full length. Do not let it pass over sharp edges or hot surfaces.
4.
Do not let oil spill on it. Do not let the power cable hang loose from the counter on which the
appliance stands.
USE
Models V90 and V100
1
Make sure the switch is in the "OFF" position.
2
On model V90, place an empty container under the spout.
3
Place the ice cubes in the container.
4
On model V90, fit the lid on the container so that the magnetic sensor is in contact with the end
of the safety arm (Fig. 5). On model V100, fit the lid so that the magnetic sensor is between the
two positioning screws (Fig. 6).
Any attempt to by-pass the safety device and use the appliance without its lid may
cause personal injury and/or damage to the appliance.
5
Start the motor by turning the switch to "ON". Run the appliance for the time necessary to crush
the ice in the container (about 30 seconds are needed to crush a full container).
6
Switch the motor off by turning the switch to "OFF".
Note: Always wait for the motor to come to a complete stop before removing the lid.
15