Publicidad
1.1.- Verify that there is a mains connection close to where the appliance is to be installed.
1.2.- Remove the TEMPLATE THAT INDICATES THE EXACT POSITION OF THE HOLES TO BE DRILLED
1
IN THE WALL from inside the packing box.
1.3.- Remove the box of accessories. This contains four sets of wall anchor supports and a connection
socket for the option of connecting the radiator to the mains by means of a plug.
1.4.- The use of a level is recommended to ensure the appliance is COMPLETELY VERTICAL.
2
2
1
2. Remove the positioning template and
box of accessories from the packing box.
The use of a level is recommended.
4
4. Place the positioning template on the
wall where the appliance is to be installed
and mark the four drill holes.
NOTES:
- 600 mm is tha minimum distance between the thermostat and the floor.
- Verify that the marks on the wall are level with respect to the floor before proceeding.
- Verify the future towel-drier radiator before proceeding.
PLANTILLA
6
TEMPLATE
5
ESCANTILHÂO
4
3
3
X 4
3. There are four sets of wall anchor supports
inside the box of accessories.
1
5
3
5. Repeat the previous step and mark the
four holes again.
Page 17
PAGE 3
1
5
2
3
4
6
7
8
2
4
Publicidad
