Publicidad
11
5
4
5
12
12. Take the HAVERLAND towel-drier radiator and support it on the four supports fixed to the wall.
Place the radiator so that the upper supports are between the second and third heater bars.
13
5
4
5
6
13. Fit the four parts 6 to the wall supports and loosely
screw in the four long screws (part 7). Align the towel-drier
radiator using a level and, when correctly aligned, tighten
the four screws 7.
7
Adjust the distance of the radiator from the wall as required
8
and, when correct, tighten the screws 5.
Your radiator is now correctly secured to the wall.
Complete the installation by fitting the four trims (part 8)
to the four supports.
The mains power cable can now be connected to the
mains power supply.
Page 19
11. LOOSELY screw the four short screws 5 in the
four fixing supports.
PAGE 5
Publicidad
