Explore Scientific RDC2002 Manual De Instrucciones página 6

CLOCK
SET THE CLOCK MANUALLY
1. Touch and hold [
condition setting.
2. The setting parameter will flash.
3. Touch [ + ] button once, the figure will increase 1 unit. Touch and
hold the [ + ] button, the figures will increase rapidly.
4. Press [ — ] button once, the figure will decrease 1 unit. Press and
hold the [ — ] button, the figures will decrease rapidly.
5. Press [ ] button to confirm setting and enter to next parameter.
6. Sequence of setting: 12/24HR  Hours  Minutes  Weather
Condition
7. If there is no action in 15 seconds or if you press [
setting will be saved and you will exit the setting mode.
12HR FORMAT SETTING
When choosing the 12HR format and set the HOUR:
1. If the minute position display
A.M.(ante meridiem)
2. If the minute position display
P.M.(post meridiem).
------ hour is A.M. 6
------ hour is P.M. 2
6
] button to enter into time and weather
, it means that the hour is
, it means that the hour is
°C/°F SETTING
Press and hold [ + ] button to switch Celsius (°C) / Fahrenheit (°F).
ALARM
SETTING/ADJUSTING ALARM TIME
1. Touch [
ALARM2 time.
2. Touch and hold [
3. The setting parameter will flash.
4. Press [ + ] or [ - ] button to set the desired data.
5. Press [
6. Sequence of setting: Alarm1 HOUR  Alarm1 MINUTE  Alarm1
snooze time  Alarm2 HOUR  Alarm 2 MINUTE  Alarm2
] button, the snooze time
7. The alarm will sound when the alarm setting is finished and
turned on.
TURN ON/OFF ALARM
Touch the [ + ] button to turn on/off the Alarm1 and Alarm2.
OPERATION
1. At the set time, alarm signal rings.
2. During the alarm, touch the [
by set minutes.
3. If you do not touch any button to stop the alarm, it will
automatically turn off after 2 minutes.
] to display the ALARM1 time. Touch again to display
] button to enter alarm setting mode.
] button to confirm setting and exit.
] button to delay the alarm