5.2 Operation
Before the first use, clean the glass lid and temperature controller according to the
instructions in section 6 „Cleaning".
Detachable temperature controller
CAUTION!
Always use the temperature controller supplied with the device. Never use
any other temperature controller!
In case the temperature controller is not plugged in correctly, abnormal
heating may occur which may lead to accidents and damages. Always make
sure that temperature regulator is tightly connected to the socket.
In case of damaging or overheating of the temperature controller, pull the plug
out and discontinue using the device. Contact the sales agent or technical
service.
As the temperature controller is a highly sensitive component, make sure it is
protected against falling, hitting or strong shocks.
Before connecting of disconnecting the temperature controller, make sure that
the dial is set to „OFF" position. Failure to observe this instruction may lead to
interruption in the device operation or overheating.
Make sure the temperature controller is plugged in tightly. When disconnecting the
temperature controller do not pull the cord but only the plug. When connecting or
disconnecting the temperature controller do not use excessive force.
Always keep dry and clean the temperature controller and poles of the socket.
Do not place the temperature controller on the heating place. Always make sure
that it does not get into contact with the heating plate.
Precautions during operation of the multipan
The heating surface is covered with non-stick coating
therefore it is required to follow precautions listed
below:Do not use sharp metallic accessories, use only
wooden or heat-resistant plastic spatulas.
Do not cut food with use of sharp knife on the pan (put
them on the plate and then cut).
- 32 -