Connections To Be Made - Axxess NITO-01 Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an ASWC-1 (sold separately), there will be an accessory wire
there to connect as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be
connected to hear sound from the factory amplifier.
• Tape off and disregard the following (13) wires, they will not be used in this
application: Blue/Pink, Blue/White, Brown, Gray, Gray/Black, Green, Green/
Black, Green/Purple, Purple, Purple/Black, Light Green, White, White/Black
From the NITO-01 harness to the aftermarket radio:
• Connect the Black wire with a ring terminal to chassis ground.
• Connect the Yellow wire to the battery wire.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
Note: Before connecting this wire, also refer to the "AX-CAM6V 12-volt to
6-volt" converter section.
NITO-01

Connections to be made

AX-CAM6V 12-volt to 6-volt converter:
12-pin pre-wired ASWC-1 harness:
2
®
• Connect the Light Green wire to the parking brake wire.
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks to the
AUX input.
• If retaining the factory backup camera, connect the Yellow RCA jack to the
reverse camera input. Please reference "Reverse camera operation" on page 4
if retaining the camera.
• Connect the Black wire to chassis ground.
• Connect the Blue/Red wire to the Red wire labeled "Camera Power 6V".
• Connect the Blue/White wire to the Green/Purple wire.
Note: The Green/Purple wire will connect to both the AX-CAM6V, and the
aftermarket radio.
• This harness is to be used along with the optional ASWC-1 (not included) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard
this harness. If it will be used, please refer to the ASWC-1 instructions for radio
connections, and also to the ASWC-1 settings on page 4 of these instructions.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.