Installing The Nito-01; Initializing The Nito-01; Adjusting The Nito-01 - Axxess NITO-01 Instrucciones De Instalación

Installing the NITO-01

With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the NITO-01 harness, into
the interface.
• Connect the NITO-01 harness to the wiring harness in the vehicle.
Note: If using the ASWC-1, connect it after you initialize and test the NITO-01,
with the key in the off position.

Initializing the NITO-01

Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an ASWC-1 connect it after you initialize
and test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation.
• Refer to "Adjusting the NITO-01", and "Extra Settings" before reassembling the dash.
®
NITO-01

Adjusting the NITO-01

Audio level adjustment:
• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise
the audio level; counterclockwise to lower the audio level.
• Once at the desired level, audio level adjustment is complete.
Audible parking sensor warning level adjustment:
• Put the vehicles gear selector in reverse and keep your foot firmly on the brake
pedal during this entire process.
Note: Do not activate the emergency brake, this will prohibit the audible parking
sensors from working.
• Have a helper walk near the rear of the vehicle to activate the parking sensors,
close enough so that the audible parking sensor warning will produce a
constant signal.
• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise
the audible parking sensor warning level; counterclockwise to lower the audible
parking sensor warning level.
• Once at the desired level, the audible parking sensor warning level adjustment
is complete. Put the vehicles gear selector back into park.
3