Altec Lansing Octiv M650 Guia Del Usuario página 17

Troubleshooting
Symptom Possible Problem
No sound from the Cable is not properly connected to
AUX device, such as the source or the speaker system.
an MP3 player or CD
Volume on the device is set
player connected to
too low.
the AUX jack
The speaker system Static electricity, momentary
exhibits erratic or interruption of power or abnormal
unexpected behavior; operating conditions may be
controls do not responsible.
function
All manuals and user guides at all-guides.com
Solution
Ensure the cable is properly connected between the source and the Octiv 650 speaker
system.
Increase the volume on the device to approximately ¾ full volume.
1. Remove your iPhone or iPod.
2. Disconnect the AC adapter cable plug from the speaker system's jack.
3. Wait 20 – 30 seconds.
4. While you wait, reset your iPhone or iPod.
5. Reconnect the AC adapter cable plug to the speaker system's jack.
6. Turn on the speaker system and check for erratic behavior. For example, adjust the
volume and see if the LEDs change.
7. If the speaker system still exhibits erratic behavior (for example, the LEDs do not
change as you adjust the volume), restore the unit's factory defaults:
A. Ensure that your Octiv 650 speaker system is powered on.
B. Press and hold the
flashing.
8. Reinstall your iPhone or iPod on the dock.
button on the speaker system until the Power LED stops
15