ctioning in order to avoid overheating and
the risk of fire.
- The internal parts of the appliance can
become very hot or produce sparks during
operation. Do not use the appliance in areas
where gasoline, paints, or other flammable
liquids are used or stored.
- It is normal for appliance's plug and cord to
feel warm to the touch. However, an exces-
sively hot or deformed plug or cord is not
normal and may be the result of a defective
electrical outlet. Defective outlets must be
replaced before using the appliance. Plug-
ging the appliance into a worn outlet may
result in overheating of the power cord or
may cause the risk of fire.
- Do not place the appliance near a bed be-
cause objects such as pillows or blankets
can fall off the bed and be ignited by the
appliance.
Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a
polyethylene tape used as a carry handle,
remove it before connecting appliance to
the outlet.
- Always disconnect the plug from the power
outlet when the appliance is not in use.
- Do not use the appliance outdoors.
- To completely turn off the appliance, push
the buttons on OFF, and then unplug the
appliance.
- Connect to properly polarized outlets only.
- Make sure that the plug is fully inserted
into the outlet. Wall outlets may deteriorate
with time, so check the plug periodically for
signs of overheating or deformation. If the
outlet has deteriorated, stop using it and
have it repaired.
- Check that neither the appliance nor the po-
wer cord have been damaged during ship-
ping.
- Make sure that no styrofoam or other pa-
cking materials remain in the appliance.
- Make sure that no pieces of polystyrene or
other packaging material have been left
between one element of the appliance and
another. It may be necessary to pass over
the appliance with a vacuum cleaner.
- The first time the appliance is used, run it at
the maximum power for at least two hours.
During this time, ventilate the room thorou-
ghly to eliminate the "new" smell released
by the appliance. It is completely normal for
the appliance to emit "creaking" sounds the
first time it is run.
- Extreme caution is necessary whenever the
appliance is left operating unattended.
- Do not open the appliance. No user-service-
able parts inside.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
A
Thermostat
B
Switches
C
Cord holder
D
Wheel
USE
Fitting the wheels
Turn the appliance upside down on a rug or soft surface to
prevent damaging the paint finish. Fully unfold the wheels
by turning them outwards (Fig. 1). Turn the appliance back
to its upright position.
Important! Always operate the appliance in upright
position only (wheels on the bottom, controls on top). Any
5
Fig. 1