Makita VC3510 Manual De Instrucciones página 16

EN
2
....
FOAM FILTER
- Rinse the foam filter with water. DO NOT use detergent.
- Replace if worn or torn.
3
....
FILTER CARTRIDGE
- To clean the filter cartridge, turn on the Self-Cleaning Filter fun-
ction by pressing the orange
up to 30 seconds. Afterwards release the momentary switch
for 15 seconds; the coil has to cool down (fig. "D5").
- Switch
(as described in point "A3").
- To thoroughly clean the filter wash it as shown in figure "D6".
Before putting the cartridge back on, make sure it is completely
dry.
Replace the filter cartridge only if worn.
Handle the filter cartridge carefully when wet (Fig. "D7").
CAUTION:
4
....
CLEANING THE DRUM (Fig. "D8")
- Check the amount of vacuumed debris.
- Empty the drum when it is half full.
- Dry off the drum and accessories after vacuuming liquids.
5
....
REPLACING THE POWER CORD
- Contact an authorized technical service centre if the power
cord has been damaged, since special tools are needed to
replace it.
(Fig. "D4")
(code 83 035BHB)
(pack code 83 201BJA *)
momentary switch
in position 0 = Self-Cleaning Filter function disabled
- 16 -
Cod.
83 035BHB
only
Cod.
83 201BJA *
*
SERVICE
Pack code