Speakers Settings; To Speakers Using Sharp's Wireless Bridge; To Wisa-Enabled Speakers. Adjust Speaker Settings Using On Screen Display - Sharp SD-WH1000U Manual De Manejo

Speakers Settings

To Speakers using Sharp's WIRELESS BRIDGE

When combining the Player with a Wireless Bridge, make the
following settings before turning on the power for the first time.
1
Set the rotary switch on the rear panel of the Wireless Bridge to
the channel of the speaker that you want to connect (L/R/C/LS/
RS/LB/RB/SW).
2
Turn on the power switch of the Wireless Bridge.
• The LED on the front panel starts to flash.
3
Turn on the power of the Player.
• The Player starts to search for the Wireless Bridge.
• When a link is established, the LED of the Wireless Bridge stops
flashing and lights.
4
When "Complete?" appears in the front panel display, press
ENTER on the remote control. When "Finish?" appears in the
front panel display, press ENTER on the remote control.
• This completes the settings on the Player and the Wireless Bridge.
While high quality audio signals from the player can be transmitted
to any WiSA-compliant speaker system, the SHARP Wireless
Bridge (VR-WR100U - SOLD SEPARATELY) can be used with
any traditional passive speaker to receive High Resolution Audio
wireless in any configuration from 2.0 to 7.1.
In the case "Output Conflict" is shown on the display, please confirm
that Rotary switch of the WIRELESS BRIDGE is correctly setup,
and turn off and on all of the system.
To WiSA-enabled Speakers. Adjust Speaker settings using on screen
display
When combining the Player with speakers that comply with a WiSA-compliant wireless audio receiver from
another manufacturer, make the following settings.
1
Turn on the power of the receiver or internal speaker.
2
Connect the Player to a display, and turn on the power.
3
From the HOME menu of the Player, select "Settings" > "WiSA Settings" .
4
Select "Manual Search" and press ENTER.
• The Player begins to search for the receiver.
5
Assign channels to each of the receiver or speakers that appear on the screen.
• This completes the settings.
• Check to confirm that sound is output correctly from each of the channels.
Rotary swich
16