Dolphin WAVE 100 Instrucciones De Manejo página 12

Press the Manual/Automatic select button and then choose the desired parameters according to the
following table:
Cleaning cycle
indicator
This determines
the length of the
cleaning cycle.
Delay time
indicator
This determines
when the pool
cleaner starts to
work. Delaying
allows the dirt
to settle to the
bottom of the
pool.
Cleaning action
indicator
Allowing you to
choose from the
following options.
Note:
• After 2 minute if no button is pressed, the Remote Control Unit will shut-down and the Pool cleaner
will continue to work in the previous settings.
• When the "Ultra-Clean" and "Walls Only" options finish their cycles, the Pool Cleaner will return to
default settings.
10
8151637_Book.indb 10
Fast Efficient
4-hour cycle 6-hour cycle for
everyday use.
(Default setting)
Immediate start One-hour delay
(Default setting)
Standard Ultra-clean
Floor and wall Stronger suction
cleaning. and slower
(Default setting) movement.
(floor and wall)
Extra
8-hour cycle
Two-hour delay
Floor only
Cleans only the
floor and the area
where the floor and
walls meet
Dolphin WAVE 100 Pool Cleaner | Operating Instructions
Walls only
Cleans walls and
waterline only
29/12/2013 10:00 AM