DeWalt DW682 Manual De Instrucciones página 9

383956-00,02,DW682 4/21/04
adjustment screw clockwise for less depth and counterclockwise
for increased depth. Each full turn causes a change in depth of
1mm (0.04"). Always check the depth adjustment by first making
test cuts in scrap wood.
4. ANTI-SLIPPAGE PINS
Plate Joiners tend to slide to the right with respect to the
workpiece when making a cut. This tendency is increased with a
dull blade or when plunging very rapidly. Anti-slippage pins have
been provided to reduce this tendency and are located on the
front registration surface on either side of the blade opening slot.
When making some joints, you may wish to retract the anti-
slippage pins so as not to scratch your workpiece in a visible area.
For this purpose, simply rotate the anti-slippage pins
approximately 1/6 of a turn and they will retract back behind the
front registration surface. A flat blade screwdriver can be used to
rotate the pins as shown in Figure 9.
5. BOTTOM REGISTRATION SURFACE
For certain applications, you will want to use the bottom surface of
the plate joiner for alignment. When using the bottom registration
surface, the adjustable fence should be set to 0° and the height
setting is unimportant. This surface is used primarily when making
'T' joints (see applications section). The distance between the
centerline of the blade and the bottom registration surface is fixed
at 3/8" (9.5mm) which allows centering on 3/4" (19mm) thick
stock. The 3 red marks on the bottom registration surface indicate
the centerline (or the deepest point) of the biscuit cut and the
approximate width of a #20 biscuit so that you'll know where the
edge of the blade is and can prevent breakthrough. To avoid
breaking through the workpiece, align the shoe so that neither
outside mark extends beyond the end of the workpiece. If either
side does, there is a good chance that the blade will break through
the surface and ruin your work.
8:20 AM Page 6
FIG 10
ROTATE ELBOW
FOR DESIRED EXHAUST
DIRECTION
FIG 11
VACUUM HOSE
CONNECTION
6