DeWalt DXGST227CS Manual Del Operador página 10

INSTALLING AND ADJUSTING THE HANDLE
Installing the Handle
1. Press and hold the handle base against the underside of the
upper shaft housing (Fig. 8).
2. Press the handle top onto the handle base until they snap
together (Fig. 8).
3. Insert the bolts (x4) into the holes (x4) (Fig. 8).
4. Tighten the bolts, but do not tighten them completely. Use a
5/32-inch (4 mm) Allen wrench.
5. Hold the unit in the operating position (Fig. 17). Move the handle
up or down the upper shaft housing to a comfortable location
(Fig. 9). Make sure the handle is positioned beyond the end of the
safety label (Fig. 9).
6. Tighten the bolts until the handle is secure.
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the bolts slightly (Fig. 8). Use a 5/32-inch (4 mm) Allen
wrench.
2. Hold the unit in the operating position (Fig. 17). Move the handle
up or down the upper shaft housing to a comfortable location
(Fig. 9). Make sure the handle is positioned beyond the end of the
safety label (Fig. 9).
3. Tighten the bolts until the handle is secure.
Bolt (x4)
Hole (x4)
Upper Shaft
Housing
Safety Label
Upper
Shaft
Housing
10
Handle Top
Handle Base
Fig. 8
Handle
Fig. 9