Tripp-Lite B302-4HX4H-4K Manual Del Propietário página 11

Operation
RS-232 Control Commands:
1) In the table below, "a" represents Input and "b" represents Output. The number value range of "a" and "b" depends on
the number of inputs and outputs of the controlled matrix. If out of range, it is considered a command input error, and the
unit will not execute the command.
2) Please note there is a punctuation mark (.) at the end of every command. This cannot be omitted.
3) Note the uppercase and lowercase letters.
Control Command Description
N. Get the number of channels
of the current matrix.
C. Get the current state of the
matrix.
SaXb. Switch Input "a" to Output "b."
Sa1Xb1, a2Xb2, Switch input a1, a2, a3 to
a3Xb3. corresponding output b1, b2, b3.
Mc. Switch between Default and
Smart EDID modes.
"c" = 0 = Default mode
"c" = 1 = Smart mode
IaEd. Set EDID of Input "a" to EDID
No. "d."
Instruction/Function
Send the command "N." and the unit will return
"N8." with 8 representing 8x8 matrix.
Send the command "C." If the current state is
11,22,33,44,55,66,78,87,
the unit will return C1X1, 2X2, 3X3, 4X4 ,5X5,
6X6, 7X8, 8X7.
Send the command "S1X2." and the unit will
switch Input 1 to Output 2.
Send the command "S1X3, 1X4." and the unit
will switch Input 1 to Output 3, 4.
Send the command "M1." and the unit will
switch EDID mode to Smart Mode.
Send the command "I2E4." and the unit will set
EDID of Input 2 as EDID No. 4 (See EDID Table)
11