Tripp-Lite B302-4HX4H-4K Manual Del Propietário página 5

Operation
The following instructions are for the 8x8 HDMI Matrix Switch/Splitter, but apply equally to the 4x4 model.
The B302-Series HDMI Matrix Switch/Splitter features three different methods of control:
1) Front-panel pushbuttons
2) IR remote control
3) TCP/IP or RS-232 control via PC or laptop
Front-Panel Pushbuttons
The following section describes how to change the inputs and outputs manually.
1) To change an input to a specific output, press the desired input (IN 1–8), then the desired output (OUT 1–8). Press
"ENTER" to confirm the new settings.
2) If you wish to send one input to more than one output display, press the desired input (IN 1-8), then the desired outputs
(OUT 1–8). Once you have selected all the desired outputs, press "ENTER" to confirm the setting changes. To select all
the outputs at once, press "ALL."
3) To preset the output EDID settings of one or all inputs, press the desired input (IN 1–8), then "EDID MENU." The LCD
screen will display the input source settings as shown below. Press "UP/DOWN" to select a preset EDID. Please see EDID
Table for a list of all the preset resolutions. Hit "ENTER" to confirm the setting.
4) To enter the output mode selection menu, press "UP ." In the menu, users can choose between Default and Smart mode.
a) Default: All displays are defaulted to output 4K x 2K @ 60 Hz or the user-defined EDID setting.
b) Smart: Outputs the lowest capable resolution of the connected displays.
To switch the mode, press "DOWN." By default, the unit comes preset in Default mode.
5