Fitting The Table - Triton RTA 300 Instrucciones De Uso Y De Seguridad

FITTING THE TABLE

Fitting to a Triton Series 2000 Workcentre
See Figs 1 - 3
1. Fit the Series 2000 Workcentre Locking Hook (5) to the
front bearing channel of the
Router Table (1) using the M4
x 35mm Countersunk Screw
(6) and M4 Hex Nut (7)
2. Locate the hook into the slot
in the front end panel of the
Workcentre and lower the
rear of the table onto the
Workcentre (Fig 2)
3. Rotate the rear locking
latches on the router table as
necessary so that they are
at right angles to the table,
with the latch bars (on the
underside of latches) outside
the table
4. This will allow the rear of
the table to sit flat on the
Workcentre bearing channels
5. Secure the table in position by
rotating the latches to engage
the bearing channels (Fig 3)
Fitting to a Triton MK3 Workcentre
See Fig 4
1. Place the Router Table (1)
behind the front end panel of
the Workcentre and rest it on
the bearing channels
2. Align the keyholes in the front
end panel of the Workcentre
with those in the front bearing
channel of the router table
and use the MK3 table locking pins to lock the table in
position
3. Secure the table as described above in steps 3 - 5 of
Fitting to a Triton Router Stand
Fig.1
See Fig 5
1. Fit the Router Table (1) over
Fig.2
2. Rotate the rear locking latches on the router table as
3. Lower the rear end of the table onto the stand
4. Secure in position by rotating the latches to engage the
Fig.3
Router Stand RSA300 Accessories
• Four hanging hooks are supplied with the Triton Router
• The two wide hooks are used for storage of the router
• The two narrow hooks are for storage of the pressure
Fig.4
• The RSA300 also has a hole in the rear panel for
'Fitting to a Triton Series 2000 Workcentre' (Fig 3)
the front end panel of the
router stand with the conical
pins (on the router stand)
locating into the holes on
the inside face of the front
bearing channel of the table
necessary so that they are at right angles to the table,
with the latch bars (on the underside of the latches)
outside the table
bearing channels on the stand
Stand RSA300; these snap onto the lower tubes of the
stand
table fence - it hangs via the scale pointer holes.
Theses hooks should be fitted to the right hand side of
the stand viewed from the switchbox end)
finger assembly, which hangs via the finger slots.
These hooks should be fitted on the left side
storage of the Protractor (3). For a tight fit, bend the tab
in the top of the hole downward slightly
Fig.5
Fitting the Table
9
GB