Troubleshooting - Orbegozo CA 08160/90 IN Manual De Instrucciones

CA 08160/90 IN
- Dip the filter into water, add detergent and leave it for 2-3 minutes. After cleaning with a brush, do not
apply too much pressure, the filter is delicate and could easily be damaged.
- You can also wash the filters in the dishwasher at 60ºC.
- The filter is made of aluminum so it is advisable not to use aggressive cleaners that can corrode it.
- Make sure the hood is switched off when cleaning.
Regular cleaning
- Clean the aluminum filters monthly. This will prevent the risk of fire. As the filters collects grease, smoke
and dust, it affects the efficiency of the hood. If the filters are not cleaned the grease can clog them.
Cleaning the hood
- To protect the hood body from corrosion, you should clean the outside of the hood with hot water and
non-abrasive detergent every 2 months. To do this, moisten a cloth with that water and clean the hood.
- Take care not to wet the engine and other interior parts, this could damage the hood.
Changing the bulb.
1. Turn off and unplug the hood.
2. Wait until the bulb has cooled before changing it.
3. Use the same type of bulb, LED 2W.
4. The bulb replacement should be performed by a qualified technician.

TROUBLESHOOTING

PROBLEM
The lights come on but the fan
does not work.
No lights or fan work.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment. The
crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of
the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage
Directive 2014/35/EU and the requirements of the EMC directive 2014/30/EU.
CAUSE
The fan is jammed
Engine is damaged
The LED bulb has blown
SOLUTION
Turn off the Hood and have it
serviced by a professional
Change the bulb for one exactly
the same
14