Adjusting The Maximum Depth Of Cut - Toro 54610 Manual Del Operador

Adjusting the Maximum Depth of Cut

DANGER
Adjusting the depth-of-cut levers could bring your hands into contact with a moving blade
and result in serious injury.
• Shut off the engine, remove the ignition key (if equipped), and wait for all moving parts
to stop before adjusting the depth of cut.
• Do not put your fingers under the housing when adjusting the depth of cut.
CAUTION
If the engine has been running, the muffler will be hot and can burn you.
Keep away from the hot muffler.
1. Shut off the machine and wait for all moving parts to stop.
2. Move the transport lever all the way back toward you into the transport position
1. Transport lever in the transport position
3. To adjust the max depth of cut, adjust the depth-of-cut lever position by pushing it in toward the machine
and moving it to a different slot
•
To raise the max depth of cut, move the depth-of-cut lever forward
•
To lower the max depth of cut, move the depth-of-cut lever rearward.
Note:
Move the depth-of-cut lever all the way forward when transporting the machine.
Figure 10
(Figure 11).
10
(Figure 10).
g340366