Progress Lighting AirPro P250069 Manual De Instalación página 8

Step 4. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly.
(Fig.9)
Step 5. Route wires exiting from the top of the
fan motor through the coupling cover, decorative
cover, canopy and then through the downrod.
(Fig. 10)
WARNING
FAILURE TO PROPERLY INSTALL
LOCK PIN AS NOTED IN STEP 6
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Ball/downrod assembly
Lock pin
Hanger pin
Set screw
Figure 9
5.
Step 6. Align the holes at the bottom of the
downrod with the holes in the collar on top of the
motor housing (Fig. 10). Carefully insert the hanger
pin through the holes in the collar and downrod. Be
careful not to jam the pin against the wiring inside
the downrod. Insert the lock pin through the hole
near the end of the hanger pin until it snaps into its
locked position, and tighten set screws as shown in
Fig.10. Cut off excess fixture wires leaving
approximately 6 to 9 inches above top of hanger
ball/downrod assembly.
Step 7. Carefully lift the assembly and rest the
hanger ball of downrod assembly on the hanger
bracket attached to the outlet box. Be sure the
groove in the hanger ball is lined up with the tab on
the hanger bracket. (Fig.11)
Motor collar
6-9 in
Coupling
Canopy
Cover
Decorative
Coupling
cover
cover
Hanger pin
Motor assembly
Figure 10
Hanger ball
Motor assembly
OK
Downrod
Figure 11
Canopy
Decorative
cover
Coulping
cover
Hanger bracket
NO