Technical Data; Charging The Battery - Hilti SD 5000-A22 Manual Del Usuario

All manuals and user guides at all-guides.com
3.9 Belt hook
Using the belt hook, the drywall screwdriver can be carried conveniently, close to the body, on a belt. The
belt hook can be fitted to allow attachment on the left or right side of the body.
3.10 Universal hook
The universal hook allows the screwdriver to be put aside or stored temporarily in a number of different
ways. If the hook is not required it can be removed by unscrewing the two retaining screws.

4 Technical data

4.1 Screwdriver
Rated voltage
Weight in accordance with EPTA procedure 01/2003
Rated speed under no load
Maximum torque
Socket/bit drive
Screw length
Screw diameter
4.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one electric tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the electric
tool. However, if the electric tool is used for different applications, with different accessory tools, or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually in use for a task. This may significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintain the tool and the accessories, keep the hands warm, organization of
work patterns.
Noise information in accordance with EN 60745
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration (vector sum of three directions), measured in accordance with EN 60745
Vibration emission value for screwdriving without impact
action (a )
h WA
Uncertainty for screwdriving
5 Preliminary and finishing work

5.1 Charging the battery

Note
Make sure that the outer surfaces of the battery are clean and dry before inserting the battery in an
approved battery charger.
Read the operating instructions for the charger for further information about the charging procedure.
▶ Use an approved charger to charge the battery.
)
WA
)
WA
)
pA
)
pA
21.6 V
2.1 kg
0 rpm ... 5,000 rpm
9.5 Nm
Hex socket / "
1
4
≤ 55 mm
≤ 4.2 mm
82 dB(A)
3 dB(A)
71 dB(A)
3 dB(A)
1 m/s²
1.5 m/s²
17