Cleaning; Dry Cleaning; Replacing The Outer Foil - Panasonic ES-WL50 Instrucciones De Funcionamiento

Using the bikini comb
1. Attach the bikini comb. (Fig. 9)
2. Slide up the pop‑up trimmer
switch, and turn the power switch
on. (Fig. 9)
3. Make the comb tightly contact
with the skin, and move the
appliance slowly. (Fig. 10)
• While using this appliance for the
first time, apply the shaver lightly
against the skin and try to shave
small areas.
• Be careful to shave areas which
are difficult to see. Otherwise it
may cause injure your skin.
After use
Store the appliance away from
sinks, bathrooms or other
high‑humidity areas where it could
be exposed to water and moisture
after use.
Leaving the appliance in a bathroom
or similar areas may cause
condensation or rust in the main body,
which may cause a malfunction.

Cleaning

• Make sure the power switch is in
the "0" position.

Dry cleaning

1. Remove the outer foil frame and
the inner blade. (Fig. 13, 14)
2. Clean with the attached brush.
(Fig. 11)
• Raise the pop‑up trimmer to clean
hair dust inside the pop‑up trimmer.
Wet cleaning
1. Remove the outer foil frame.
2. Rinse with cold or warm water.
10
ES-WL50_EU v5.indb 10
3. Wipe with a dry cloth, and dry
completely in a well‑ventilated
area. (Fig. 12)
• Use a dry cloth to wipe away any
substances on the blade.
• Remove the outer foil frame to dry
it quicker. (Fig. 12)
• Do not wipe the main body with
alcohol, nail polish remover, or the
like.
Doing so may result in
malfunction, breakage of parts,
discoloration, or the like.
Removing and attaching the
outer foil frame (Fig� 13)
• Remove the outer foil frame by
pushing the frame release buttons
on both sides.
• Attach the outer foil frame evenly
until it clicks.
Removing and attaching the
inner blade (Fig� 14)
• Remove the inner blade by holding
the both ends and pulling straight
away from the main body.
• Insert the inner blade by holding the
both ends and pressing downward.

Replacing the outer foil

• Remove the outer foil only when
replacing it.
• Make sure the power switch is in
the "0" position.
1. Pull the outer foil forward by
holding the two hooks (a) inside
the outer foil. (Fig. 15)
2. Hold the two hooks and insert the
outer foil into the outer foil frame
until it clicks. (Fig. 16)
18/11/30 下午6:17