Oleo-Mac PW 125 C Manual Del Usuario página 23

- In direct sunlight, with a surrounding temperature greater than 40°C/104°F.
• If used under very low temperatures, make sure that ice has not formed inside the pump and the
pipes.
• In order to avoid incrustations and/or deposits of chemical products after using detergents, the
circuit should ideally be cleaned by aspirating clean water for a few seconds.
• Carry out the foreseen routine maintenance controls with particular reference to the oil.
• The machine does not like frost.
To avoid the build-up of ice inside the machine in harsh environments, a car anti-freeze product
can be aspirated before carrying out the
because the pumped liquid could damage the high-pressure seals of the pump. If
TECHNICIAN
the machine could not be protected as previously indicated, place it in a warm location for a
sufficient time before starting so that the ice that has formed inside can melt: The machine could
be seriously damaged if these simple instructions are not followed.
ADDITIONAL PRECAUTIONS FOR MACHINES
• To supply the maximum power, the internal combustion engine must be run-in for at least 10
hours at a load less than 15÷20 % in relation to the maximum performance of the machine.
• The maximum power that the internal combustion engine can supply diminishes as the altitude
and the surrounding temperature rises (there is an approx drop of 3.5% every 305 m/1000 ft
above sea level and 1% every 5.6°C/42°F over 16°C/61°F). If the machine is used at high altitudes
or in high surrounding temperatures, refer to the instruction manual of the internal combustion
engine for the necessary precautions to be adopted.
• Ideally the engine should be left to warm up for a few minutes before expecting the maximum
performance of the machine.
• Do not leave the high-pressure water cleaner in by-pass for more than three minutes (gun
closed) unless an optional thermostatic valve has been installed by a
Nevertheless, remember that the thermostatic valve can only be installed if the machine will
always operate with a mains water supply.
ADDITIONAL PRECAUTIONS FOR HOT WATER FED MACHINES
• If the machine is used at an altitude over 1000 m/3281 ft, contact a
a control and to make any necessary adjustments to the combustion.
• If diesel fuel for agricultural purposes or for heating is used or if it is dirty it will cause excessive
deposits on the burner thereby compromising its correct functioning.
• Before proceeding with the
a few minutes in order to cool the delivery circuit.
• To avoid malfunctions on machines equipped with high-pressure detergent distribution, keep
the detergent adjustment knob
• close the detergent adjustment knob when finished with the detergent.
FULLY
• To prevent problems with the metering pump, in the absence of descaling fluid, fill the related
tank with water.
"STOP"
WITH INTERNAL COMBUSTION ENGINE
procedure after use, run the machine with the burner off for
"STOP"
closed, with the tank empty.
FULLY
procedure. Before doing so, contact a
QUALIFIED TECHNICIAN
QUALIFIED
QUALIFIED TECHNICIAN
GB
.
for
23