Preparations At The Workplace; Charging The Battery; Inserting The Battery; Removing The Battery - Hilti HURON DSH 600-22 Manual De Instrucciones

4.4 Sound emission (in accordance with international standard)
Sound emission in accordance with EN ISO 3744
(L )
wa
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 8
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the battery release button.
2. Remove the battery from the product.
5.4 Installing cut-off wheel
WARNING
Risk of injury and damage. Damaged cut-off wheels may break.
▶ If the cut-off wheel has been subjected to an impact, check the cut-off wheel for damage and replace it
if necessary.
▶ Never use cut-off wheels that are damaged, run untrue or vibrate.
▶ Don't use synthetic resin-bonded fiber-reinforced cut-off wheels which have exceeded their use-by date
or already softened due to water absorption.
CAUTION
Risk of injury and risk of burns! Cut-off wheels become hot when in use and can have sharp edges that
lead to injuries.
▶ Wear protective gloves for installing, removing and adjusting the accessory tool or other components,
and during troubleshooting operations.
Install only the clamping flange that is suitable for the cut-off wheel used. The outside diameters are
stated in the technical data.
Clamping flanges specially designed for diamond cut-off wheels bear the following wording by way of
identification: "ONLY FOR DIAMOND WHEELS".
1. Remove a mounted dust extraction module (accessory). → page 13
*2284138*
DSH 600-22
107 dB(A)
3
2284138 English 11