Husqvarna EPOS Reference station Manual De Usuario página 6

3.4 Installation of the product
Read and understand the instructions about the
To examine where to put the
reference station. Refer to
reference station on page 5 .
Read the Operator's manual for the robotic lawn mower
to be used together with the reference station.
You can install the reference station on a post or a wall.
CAUTION:
Movements of the reference
station will affect the correction data sent to
the product with the accurate position. The
reference station must be installed tightly on
the post or wall.
CAUTION:
The items on the map will
change position if you move the reference
station. Adjust the items on the map or do
the installation again in the Automower
Connect app.
3.4.1 Installation tools
• Screwdriver, Torx 20.
• Hex key, 4 mm. Included in the carton.
3.4.2 To install the reference station on a
post
1. Attach the post tightly to a wall, roof top or the
ground. Make sure that the post cannot move or
be accidentally moved.
2. Attach the support bracket and one of the post
brackets to the arm with the 4 screws (4 mm hex
key).
Note:
The post brackets are available in 2
dimensions to fit different dimensions of the post.
Select the applicable post bracket for your
installation.
6 - Installation
3. Put the arm on top of the post.
Note:
The reference station must be installed at
®
the top of the post.
4. Attach the reference station to the post with the 2
screws (4mm hex key).
5. Pull the cable on the reference station through the
slot in the arm and install the reference station on
the arm.
1512 - 002 - 08.11.2021