Husqvarna EPOS Reference station Manual De Usuario página 8

4. Put the cable of the reference station through the
slot in the arm and install the reference station on
the arm.
5. Attach the connector to the clips on the arm.
8 - Installation
6. Tighten the screw (Torx 20) on the arm of the
reference station.
T20
7. Connect the low-voltage cable to the reference
station and the power supply.
8. Attach the low-voltage cable to the wall from the
reference station to the power supply with cable
ties.
CAUTION:
cable is not attached tightly with cable
ties it can be damaged in hard wind.
9. Put the power supply at a minimum height of 30
cm / 12 in. from the ground. Refer to
where to put the power supply on page 5 .
10. Connect the power supply cable to a 100-240V
power outlet.
11. Wait until the LED status indicator is solid green.
First the LED status indicator is flashing green for
some minutes. Refer to
reference station on page 9 .
If the low-voltage
To examine
LED indicator lamp on the
1512 - 002 - 08.11.2021