Connecting To Network - JetNet 3008G Serie Guía De Instalación Rápida

Connecting to Network

Connecting the Ethernet Ports: Connect one end of an Ethernet cable into the UTP port of
JetNet 3008G/3005G, while the other end is connected to the attached networking device.
All UTP ports support auto MDI/MDIX function. The Speed LED will turn on for gigabit link
and turn off for 10/100Mbps link, the LNK/ACT LED will turn on for link up and blinking for
packet transmit and receive.
DIP Switch Settings for Alarm Relay Output
JetNet 3008G JetNet 3005G
Pin No. Pin No.
Pin 1 ~ 8 Pin 1 ~ 5
Pin 9 Pin 6
Korenix Customer Service
KoreCARE is Korenix Technology's global service center, where our professional staffs are
ready to solve your problems at any time.
Korenix global service center's e-mail is KoreCARE@korenix.com
Status Description
To enable port link down alarm at this port.
ON
To disable port link down alarm at this port.
Off
To enable power failure alarm.
ON
To disable power failure alarm.
Off