Beninca RR.1WBV Manual Del Usuario página 9

433.92MHz single/dual channel rolling-code radio receivers
compatible with the ADVANTAGE system.
They are available with Molex socket or in a plastic box with
terminal board. The standard memory can hold a maximum
of 512 rolling-code transmitters. A special version is available
with a memory that can hold 2048 transmitters. A full memory is
indicated by 10 orange blinks.
N.B: The Advantage palm programmer and related management
software permit the use of certain advanced functions, please
consult the relevant instruction manual for more information.
To optimise reception install the antenna away from metal
bodies and avoid positioning several receivers next to each
other. If no antenna is used reception will be considerably
reduced.
Memorising transmitters – Simplified procedure
To merely record one or more transmitters to activate the first
channel, follow this simplified procedure:
1 Press and release the button P on the receiver.
2 The Red LED will light up for 3 secs, then go out for 1 sec and
then light up again for 5 secs.
3 While the red LED is on, press the button on the transmitter
to associate with channel 1.
4 Other transmitters can be then be recorded by pressing a
button within 5 secs from recording the previous transmitter.
5 To end wait 5 secs, the receiver will exit programming.
ENGLISH
Note
Memorising a transmitter – Remote self-learning
If a transmitter has already been memorised on the receiver the
remote radio self-learning feature can be used (without having
to use the receiver button P).
Proceed as follows:
1 Press the hidden button on the memorised transmitter.
2 Press, within 5 secs., the button on the memorised transmit-
ter corresponding to the channel to associate with the new
transmitter.
3 Press, within 5 secs., the button on the new transmitter to
associate with the channel selected at point 2 above.
4 The receiver will memorise the new transmitter and promptly
exit programming.
Programming
Transmitters can be memorised and separate channel modes
can be set using the button "P" (see Fig.1/2).
To go from one programming mode to the next press the button
P within 3 secs from one press and another.
Once having selected a programming mode, wait for about 3-4
secs and a LED signal with indicate that programming has been
entered (see "Operations" column).
Table 1 lists the various programming modes.
9