Acson international G18 Manual De Operación página 5

1. Transmission source
• The source where the signal will be transmitted.
2. Signal transmission indication
• Blink to confirm that the last setting has been transmitted to the unit.
3. Temperature setting
• To set the desired room temperature, press the ▲ or ▼ button to increase or
decrease the set temperature.
• The temperature setting range is from 16°C to 30°C (Optional setting 20°C
to 30°C).
• Press both buttons simultaneously to toggle ▲ and ▼ from °C to °F setting.
4. Personalize setting
• Press
and .
• Set the desire setting, then leave the handset for 4s without pressing any key
and it will save the setting into the programme.
• Press once to activate the P1 setting, press again to cycle between P1 and P2.
• Press any key to deactivate the personalize setting.
5. Automatic air swing (optional)
• Press the SWING
• To distribute the air to a specific direction, press the SWING
wait until the louver move to the desired direction and press the button once
again.
6(a). Silent function
• Press
• Fan speed turn to minimum speed.
• Press again to deactivate the function.
• The Silent function ( ) is unavailable for chiller water system.
6(b). Ionizer setting (optional)
• Press
• Press again to deactivate the function.
7. Sleep mode setting
• Press the SLEEP button will activate the sleep mode function.
• This is an energy saving option. When the
unit is operating under cooling mode, the
set temperature is increased by 0.5°C after
the first half an hour, another 0.5°C after
the second half an hour and 1°C after the
following 1 hour.
• When the unit is operating under heating
mode, the set temperature is decreased by
1°C after the first half an hour, another 1°C
after the second half an hour and 1°C after
the following 1 hour.
• This function is available under COOL,
HEAT and AUTO mode.
OM-G18-0107-Acson
OPERATING GUIDE
and hold for 3s, then
button to activate the automatic air swing function.
for quiet operation.
will activate the ionizer function.
1
1
will blink. Press again to cycle between
+2 C
+1 C
- 1 C
- 2 C
- 3 C
0 0.5
8/29/08, 3:47 PM
button and
1 1.5 2