Fitting The Side Brush - Cleanfix HS770 Instrucciones De Uso

The sweeper has only been partially assembled for packaging reasons.
The pushing handle and side brush arm must be fastened to the frame.
Fitting the pushing handle
 Unpack the sweeper and place it on a flat surface.
 Remove the refuse container and unpack the parts packed inside it.
 Check that all parts and also the instructions have been removed from the carton.
 Fit the pushing handle lower section (1) into the frame and fasten it with the bolts (2).
 Press in the plastic plug (3).
 Fasten the pushing handle upper section (4) to the lower section with the screw (22) and the wing nut (23).

Fitting the side brush

 Fit the side brush arm (5) into the mounting provided on the frame. Insert the sleeve (6).
 Slip the fastening bolt M 8 x 40 (7) from the inside to the outside and properly tighten the self-locking nut (8).
 Fold up the side brush arm.
 Place the drive belt (9) in the groove of the drive wheel (10) and in the guides (11) provided. Fit the upper part
of the drive belt first into the pulley (12) and then into the groove of the brush plate (14). Then pull it between
the brush plate (14) and the pulley (13).
 Fit the side brush (16). Place the deflecting plate (15) on the brush plate (14) such that the open side is visible.
Place the side brush (16) on it and fasten it using the three special screws (17). The deflecting plate must
turn easily.
 Swing down the side brush arm (5) and ensure that the drive belt (9) passes under the guide hook (18).
 Position the refuse container (19).
 The sweeper is ready to go.
 If the side brush (16) turns in the wrong direction, the drive belt has not been fitted correctly.
6 | 6 | 6 |
- ASSEMBLY -