Viesta DWP70 Manual De Instrucciones página 7

Step 4:
Install the glass panel as shown in the figure below.
Attach the support rod as follows:
The support rod should be positioned in a right angle from the wall and with a maximum 7.8 inches (20 cm)
●
from the corner of the glass.
To mount the rod drill a Ø 0.3 inch (8mm) and 1.8-2 inches deep hole. Insert the dowel into the drill hole.
●
Now mount the support rod onto your wall.
●
Before you place the support rod on the glass element place the supplied padding to avoid direct contact of
●
the glass to the metal, risk of breakage.
Step 5:
Seal the joints between the frame and the wall with silicone.
Remove excess silicone and allow the silicone to set for 24 hours. Avoid any water contact during this time.
INSTALLATION
A
E
D
[ EN ● 7 ]
Version: 1.0
KEN001DW 21.07.2017
1.
A
2.
Ø 8mm
3.
C
4.
B
5.
A