Bang & Olufsen BeoSound 2 Manual Del Usuario página 6

English
Illustrations supporting the
procedures described below are
located in the beginning of this
Guide. For further information,
refer to the On-screen Guide (in
any Bang & Olufsen music player).
Installation and connection
1 Insert the included memory card
into BeoSound 2.
2 Insert the CD-rom in your PC's CD
drive. If the Setup program starts
automatically, go directly to 5.
Otherwise, go to 3.
3 Select your CD drive.
4 Double-click the 'Setup' file.
5 Follow the on-screen instructions.
Get started
To download music tracks,
BeoSound 2 must be placed on the
base, then:
> Access your music player (i.e.
BeoPlayer, BeoLink PC 2 or
Windows Media Player 7.0 or
newer). If you are using a Bang &
Olufsen music player, move your
mouse to the right side of the
screen, and click the triangular tab
which appears.
> Click N.MUSIC twice to access your
folders and tracks.
> Click PORTABLE to see the music
content on BeoSound 2. A
BeoSound 2 Playlist opens.
> To transfer tracks from your lists to
BeoSound 2, simply drag and drop
a track from a list to the
BeoSound 2 Playlist. An indicator
below the track shows the status
of the downloading progress.
If you don´t have music stored on
your PC, access the On-screen Guide
for information on how to record
music from an audio CD to use on
your PC. The On-screen Guide is
All manuals and user guides at all-guides.com
located at the bottom of the control
bar in any Bang & Olufsen music
player. Simply press 'Guide'.
Recharge battery
When the built-in battery requires
recharging, a beep, repeating every
30 seconds, will sound from
BeoSound 2. You can silence this
signal by pressing GO on the keypad
once.
Place BeoSound 2 on the base.
Recharging begins. You can leave
BeoSound 2 on the base without risk
of overcharging the battery.
An 80% battery charge is reached
after approximately one and a half
hours, and a full charge is reached
after approximately two and a half
hours. Starting from a fully-charged
state, the battery in BeoSound 2 will
provide approximately 7 hours of use.
Reset BeoSound 2
If BeoSound 2 doesn't respond, you
can reset it. Press and hold ∧ ∨ GO
simultaneously for two seconds. This
resets BeoSound 2. No data will be
lost.
Memory card
MultiMedia (MMC) and Secure
Digital (SD) cards from SanDisk and
similar products are compatible. You
can write-protect an SD card by
moving the slider down.
Earphones
For maximum sound quality,
assemble, place and adjust the
Earphones as shown in the beginning
of this Guide. BeoSound 2 switches
to standby if you disconnect the
Earphones.
WARNING! Prolonged use at high
volume may cause hearing damage!
Cleaning BeoSound 2
Wipe dust off the surfaces using a
dry, soft cloth. Remove grease stains
or dirt with a lint-free, firmly wrung
cloth, dipped in a solution of water
containing only a few drops of mild
detergent, such as washing-up liquid.