Product Description; Intended Use; Installation And Connection - Pontec PondoSwitch Instrucciones De Uso

Product description

 A PondoSwitch
1 Power supply for the pump
2 Outlet AG
3 Power connection cable
4 Pressure gage
5 Inlet (can be rotated)
6 Adapter
7 START PUMP button
8 Dry run indicator lamp, red
9 Operating indicator lamp, green

Intended use

Only use the product described in this manual as follows:
• Automatic activation and deactivation of a water pump (pressure pump) when water is taken by a connected appli-
ance.
• Operate the product in compliance with the technical data. (→ Technical data)
Possible incorrect use
The following restrictions apply to the unit:
• Not suitable for pumps with an integrated automatic control system.
• Do not connect to the drinking water supply.
• Not suitable for drinking water.
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.

Installation and connection

NOTE
Excessive water pressure in the system will damage the unit.

Ensure that the distance from the highest water withdrawal point does not exceed 49 ft.

Ensure that the system pressure does not exceed 10 bar.

Adhere to the maximum permissible pump pressure. It may be less than 10 bar.
NOTE
Ensure that all connection lines are completely leak-tight, as leaking lines can impair the function of the system and
lead to damage.

Use a suitable sealant to seal the threads of the lines and the connection to the pump.
 Overtightening of plastic screw connections can lead to damage. Do not apply excessive force.
 B
The unit can be connected horizontally or vertically at any point between the pressure connection of a garden pump,
deep well pump or submersible pressure pump and the first water withdrawal point (e.g. washing machine).
• Recommendation: Fit directly to the pressure connection of the pump. Use an adapter.
How to proceed:
 C
1. Screw the adapter onto the pump.
– Ensure that the O-ring is correctly positioned.
2. Screw the unit onto the adapter.
– During installation, ensure that the arrow on the cover and the outlet of the unit point in the direction of the water
flow.
3. Connect the unit to the downstream line.
- EN -
11