Technical Data - Beurer LB 37 Manual De Instrucciones

Problem
The mist has a strange
smell
Strange noise
Mist escapes underneath
the water tank
The LED lights up red
although the tank is full

10. Technical data

Dimensions (LxWxH)
Cable length
Mains voltage/frequency
Nominal power
Room size
Capacity
Evaporation output
Signs and symbols
Volume
Cause
The device is new.
Stale or dirty water.
The water tank is not positioned
correctly on the base unit.
There is too little water in the water
tank.
The device is not level and unsta-
ble.
The water tank is not positioned
correctly on the base unit.
The device evaluates the water
level incorrectly due to a fault.
approx. 21 cm x 11 cm x 25,5 cm
approx. 1.5 m
100 – 240 V AC / 50/60 Hz
max. 20 W
up to 20 m²
approx. 2 litres
200 ml/hour
The unit is double-protected and thus corresponds to protection
class 2.
approx. 35dB
Solution
Remove the water tank, turn the screwed plug
and remove it.
Air the open, emply water tank in a cool, dry place
for twelve hours.
Empty the base unit and the water tank and clean
them thoroughly.
Fill the water tank with fresh water.
Lift up the water tank and position it correctly on
the base unit.
The tank should sit tightly on the base unit.
Fill the water tank.
Place the device on a firm, level surface.
Lift up the water tank.
Check whether the join between the base unit
and water tank is clean.
Clean if required.
Position the water tank correctly on the base unit.
The tank should sit tightly on the base unit.
Restart the device.
18