Power-Cord Caution - Onix OP 101 Guia Del Usuario

Thank you for purchasing ONIX Electronics. With sincere appreciation, we suggest that you should read this User's
Manual thoroughly before operation and keep the Manual properly for further reference. .
INSTALLATION
I n s t a l l t h e u n i t i n a we l l ve nt i l ate d p l a ce a n d n o t
exposed to high temperatures or humidity, nor any heat
sources such as heaters or radiators. Be sure to leave
space around the unit for ventilation to improve heat
radiation (at least 30 cm at top, 10 cm at rear, and 20 cm
at each side). If not enough space is provided between the
unit and walls or other equipment, heat will build up inside, interfering with performance or causing malfunctions.
CONNECTIONS
Before making or changing the connections, switch o the power switch to prevent damaging the product.
To connect the speakers, always check the correct polarity (red +) (black -) to avoid damaging them irreparably.
CONNECTING THE PIN-RCA CORDS
1
Left channel
3
White plug
Connect the white plug 3 to the L (left) channel 1,
and the red plug 4 to the R (right) channel 2.
Be sure to push the plugs securely.
MAINTENANCE OF EXTERNAL SURFACES
Remove dust and dirt with a clean, dry cloth.
Never use solvents, gasoline, insecticide sprays and other chemicals on or near the equipment because they can
corrode the surfaces.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord
when your hands are wet as this could cause a short circuit or electric shock.
The preampli er is equipped with lters for the suppression of radio interference in accordance with EEC regulation
USER'S GUIDE
L
2
Right channel
R
4
Red plug
CONNECTING THE SPEAKER CORDS
10mm
1.
Twist the wire core.
2.
1 2
1. Strip o the vinyl covering and twist the tip of
the wire core.
2. Loosen the knob and insert the wire core into
the terminal hole.
3. Tighten the knob to x the wire core in place.
3.
3