Basic Operation; Power On/Off; Select The Correct Tv System; Change System Menu Language - Vieta Home VH-MS350SL Manual De Usuario

Basic Operation

Power On/Off

You can use all the functions on the panel of the unit
or the remote control after connecting to power supply
(called Standby Mode).
Turning the System On
Press the button to turn the system on from stand-
by mode.
Note:
When turning the system on, the system will continue
in the mode it was in when it was turned off last time.
Turning the System Off
Press the button again to turn the system off and
go to standby mode.
Note:
Be sure to unplug the power cord from the outlet
when the system is not in use for an extended period
of time.

Select the correct TV system

Change this setting if the video does not appear cor-
rectly. By default, this setting matches the most com-
mon setting for TV in your country.
1 No disc mode, press the SETUP button.
2 Select [Preference Page].
3 Select [TV Type] and then press the
4 Select a setting and then press the ENTER button.
- [PAL] - For TV with PAL color system.
- [Auto] - For TV that is compatible with both
NTSC and PAL (multi-system).
- [NTSC] - For TV with NTSC color system.
5 To exit the menu, press the SETUP button.

Change system menu language

1 Press the SETUP button.
2 Select [General Setup Page].
3 Select [OSD language] and then press the
4 Select a setting and then press the ENTER button.
5 To exit the menu, press the SETUP button.

Setting the Clock

The built-in clock shows the correct time in the dis-

play.

1 In standby mode, press and hold the CLOCK
button to activate the clock setting mode, hour
indicator will blink.
2 Set the hour with the
3 Press the ENTER or CLOCK button to confirm,
minute indicator will blink.
4 Set the minute with the
5 Press the ENTER or CLOCK button to confirm,
the built-in clock starts operating and the seconds
start counting from 0.
button.

button.

button or button.
 
button or button.
 
Note:
* The operating time of every step shouldn't be
longer than 15 seconds or it will return to the
original display.
* If there is a power failure or the power system is
turned off, the clock will lose its setting.
* When you press the CLOCK button, the clock time
is displayed. Wait for a few seconds until the
display returns to the original display.

Adjust volume level

During play, press the VOL+/- buttons to increase/
decrease the volume level.

Select a preset sound effect

During play, press the EQ button repeatedly to select:
[FLAT] , [Pop] , [Classic] , [Rock] , [Jazz] , [Vocal]

Super Bass boost

Press the BASS button repeatedly to select the base
boost level.

Mute sound

During play, press the MUTE button to mute or re-
store sound. Press this button again or VOLUME+
button to cancel the effect.

Adjust brightness of display panel

Press the DIM button repeatedly to select different
levels of brightness for the display panel.
Play

Play a disc

Caution!
- Never look at the laser beam inside the unit.
- Risk of product damage! Never play discs with
accessories such as disc stabilizer rings or disc
treatment sheets.
- Never put any objects other than discs into the
disc compartment.
1 Press the DISC button to select the DISC source.
2 Use the ' button to open the disc tray.
3 Place a disc onto the disc tray (with the printed
side up) and use the ' button to close the disc tray.
4 The unit will read the disc and play it automati-
cally.
- To stop play, press the 3 button.
- To pause or resume play, press the 12 button.
- To skip to the previous/next title/chapter/track,
31