Spark Arrester; Helpful Tips & Suggestions; Storing Your Engine - Honda GXV340 Manual Del Propietário

SPARK ARRESTER (applicable types)
The spark arrester may be standard or an optional part, depending
on the engine type. In som e areas, it is illegal to operate an engine
without a spark arrester. Check local laws and regulations. A spark
arrester is available from authorized Honda servicing dealers.
The spark arrester must be serviced every 100 hours to keep it
functioning as designed.
If the engine has been running, the m uffler will be hot. Allow it to
cool before servicing the spark arrester.
Spark Arrester Removal
1. Rem ove the three 5 m m screws from the m uffler protector.
2. Remove the 8 m m bolt and the two 8 m m nuts, and rem ove the
m uffler protector, identification plate, m uffler and gasket from
the cylinder.
3. Remove the spark arrester from the m uffler (take care not to
damage the wire m esh).
MUFFLER
GASKET

SPARK ARRESTER

8 mm BOLT
IDENTIFICATION PLATE
Spark Arrester Cleaning & Inspection
1. Use a brush to rem ove carbon
deposits from the spark arrester
screen. Be careful not to damage
the screen. Replace the spark
arrester if it has breaks or holes.
2. Install the gasket, spark arrester, muffler, identification plate,
and m uffler protector in reverse order of rem oval.
All manuals and user guides at all-guides.com
MUFFLER PROTECTOR
5 mm SCREW (3)
8 mm NUT (2)
SPARK ARRESTER
SCREEN
ENGLISH
HELPFUL TIPS & SUGGESTIONS

STORING YOUR ENGINE

Storage Preparation
Proper storage preparation is essential for keeping your engine
trouble-free and looking good. The following steps will help to
keep rust and corrosion from im pairing your engine's function and
appearance, and will m ake the engine easier to start when you use
it again.
Cleaning
If the engine has been running, allow it to cool for at least half an
hour before cleaning. Clean all exterior surfaces, touch up any
damaged paint, and coat other areas that may rust with a light film
of oil.
Using a garden hose or pressure washing equipment can force
water into the air cleaner or muffler opening. Water in the air
cleaner will soak the air filter, and water that passes through the
air filter or muffler can enter the cylinder, causing damage.
Fuel
Gasoline will oxidize and deteriorate in storage. Deteriorated
gasoline will cause hard starting, and it leaves gum deposits that
clog the fuel system. If the gasoline in your engine deteriorates
during storage, you may need to have the carburetor, and other
fuel system components, serviced or replaced.
The length of tim e that gasoline can be left in your fuel tank and
carburetor without causing functional problem s will vary with
such factors as gasoline blend, your storage tem peratures, and
whether the fuel tank is partially or completely filled. The air in a
partially filled fuel tank promotes fuel deterioration. Very warm
storage tem peratures accelerate fuel deterioration. Fuel problem s
may occur within a few months, or even less if the gasoline was
not fresh when you filled the fuel tank.
Fuel system damage or engine performance problem s resulting
from neglected storage preparation are not covered under the
Distributor's Limited Warranty .
You can extend fuel storage life by adding a gasoline stabilizer
that is form ulated for that purpose, or you can avoid fuel
deterioration problem s by draining the fuel tank and carburetor.
11