TOPDON ARTLINK 400 Manual Del Usuario página 6

FAQ
Q: The system stops/freezes when reading a data stream. What
should I do?
A: It may be caused by a loose connector. Please unplug the
connector and plug it in again to retry.
Q: Why does the screen flash during ignition?
A: It may be caused by electromagnetic interference,
which is normal.
Q: Why are there so many fault codes?
A: Usually, it's caused by a poor connection or a ground fault.
Q: Why can't the DTCs be erased?
A: Confirm the malfunction related to DTCs has been properly
fixed. Next, switch the ignition OFF. Wait for 1-3 minutes, then start
the vehicle. Finally, try to run "Read Codes" again. (Some DTCs
can only be erased in this way.)
9
Warranty
TOPDON One Year Limited Warranty
TOPDON warrants to its original purchaser that TOPDON
products will be free from defects in material and workmanship
for 12 months from the date of purchase (Warranty Period). For
the defects reported during the Warranty Period, TOPDON will,
according to its technical support analysis and confirmation, either
repair or replace the defective part or product.
The TOPDON shall not be liable for any incidental or consequential
damages arising from the use, misuse, or mounting of the device.
Some states do not allow limitation on how long an implied
warranty lasts, so the above limitations may not apply to you.
This limited warranty is void under the following conditions:
Misused, disassembled, altered or repaired by unauthorized stores
or technicians.
Careless handling and violation of operation.
Notice:
All information in this manual is based on the latest information
available at the time of publication and no warranty can be made
for its accuracy or completeness. TOPDON reserves the right to
make changes at any time without notice.
10