Optional Accessory - Makita GA7070 Manual De Instrucciones

For tool with clamp lever type wheel
guard

Optional accessory

WARNING:
The wheel guard must be fitted
on the tool so that the closed side of the guard
always points toward the operator.
Loosen the nut, and then pull the lever in the direction
of the arrow.
2
► 1. Nut 2. Lever
Mount the wheel guard with the protrusions on the
wheel guard band aligned with the notches on the bear-
ing box. Then rotate the wheel guard to such an angle
that it can protect the operator according to work.
1
2
► 1. Wheel guard 2. Bearing box
► 1. Wheel guard
Securely tighten the nut using a spanner, and then
close the lever in direction of the arrow to fasten the
wheel guard. If the lever is too tight or too loose to
fasten the wheel guard, open the lever and then loosen
or tighten the nut using the spanner to adjust the tight-
ening of the wheel guard band.
► 1. Nut 2. Lever
To remove wheel guard, follow the installation proce-
1
dure in reverse.
Installing or removing depressed
center wheel or flap disc
Optional accessory
WARNING:
wheel or flap disc, the wheel guard must be fitted
on the tool so that the closed side of the guard
always points toward the operator.
CAUTION:
of the inner flange fits into the inner diameter of
the depressed center wheel / flap disc perfectly.
Mounting the inner flange on the wrong side may
result in the dangerous vibration.
Mount the inner flange onto the spindle.
Make sure to fit the dented part of the inner flange onto
the straight part at the bottom of the spindle.
Fit the wheel / disc on the inner flange and screw the
lock nut with its protrusion facing downward (facing
towards the wheel).
1
► 1. Lock nut 2. Depressed center wheel 3. Inner
flange
9 ENGLISH
2
When using a depressed center
Make sure that the mounting part
1
1
2
3