How To Set The Room Temperature Sensor; How To Set The Address Switch - Toshiba TCB-AX21E Manual De Instalación

Heronhill - for all your Toshiba requirements

How to set the room temperature sensor

• The room temperature sensors are equipped in the indoor unit and the wireless remote controller.
One of two sensors works.
• The room temperature sensor is set to the indoor unit side at the shipment from the factory.
To select the sensor in the remote controller, push the SENSOR button (Right figure) inside of the
remote controller cover and check "Main sensor" disappears from LCD.
NOTE :
If the room temperature data from the remote controller is not
transmitted to the unit for 10 minutes or more, the sensor at
indoor unit side is automatically selected even if the sensor at the
remote controller side is selected.
Fix the remote controller toward the unit as possible.

How to set the address switch

• When the multiple sensors are installed in the same room, an address can be set to prevent cross
communication.
• When replacing the battery and pushing SET button, the address of the remote controller becomes
[ALL] and the sensor is enabled to receive signal regardless of setting of address switch of the opera-
tion section.
• For selecting of the remote controller address, refer to Owner's Manual.
• Change the address of the sensor by removing screws of P.C. board cover of the sensor unit. After
then, fix the cover with screws using a clamp.
Display of Address
remote
controller
address
Address switch Address
position of switch of
sensor sensor unit
can be set any
position.
Tel: 01823 665660 www.heronhill.co.uk Fax: 01823 665807
All manuals and user guides at all-guides.com
Address
8
Address
• • • • •
• • • • •
Sensor
button
Address