How To Perform Cabling Of Sensor Units - Toshiba TCB-AX21E Manual De Instalación

Heronhill - for all your Toshiba requirements

How to perform cabling of sensor units

Flush Mounting
• Connection diagram
• Provided wire joint (WHT 2)
1. Strip the insulation to approximately 14 mm
from the ends of the wires to be connected.
2. Twist together the 2 wires and create a crimp
connection at the wire joint.
3. If a special crimping tool is not used, or if the
connection is soldered, insulate the wires
using insulation tape.
Exposed Mounting
• Connection diagram
Tel: 01823 665660 www.heronhill.co.uk Fax: 01823 665807
All manuals and user guides at all-guides.com
Indoor unit remote
controller terminal
board
Wire of
receiver unit
(field supply)
Wire of receiver unit
(field supply)
Power wire from
receiver unit
Indoor unit remote
controller terminal
board
6
Separate receiver
unit
Power wire from
receiver unit
Connector
Wire joint CE-1
(provided)
Remote controller cord (optional)
Separate receiver
unit